ECS Automotive ConceptsRust Prevention Magic
HomeNew Products!ProductsWhy Choose E.C.S?Ordering InformationContact E.C.S.



Rust Prevention Magic
   Rust Prevention Magic
   How-To
   F.A.Q.
   2011 SEMA Award.
   RPM Test Data

Date Coded Glass

VIN Data Decals

Chrysler Exhaust Systems
   E-Body Exhaust
   B-Body Exhaust
   Videos / Sounds

 All Chrysler Products
   Date Coded Glass
   Exhaust Systems
   Engine/Exhaust/Axle
   Lights/Electric
   Interior/Exterior
   Trunk Area Decals
   Chrysler VIN Decals
   Decal Packages
   Metal Parts

All Ford Products
   Date Coded Glass
   Engine Area
   Lights/Electrical
   Interior/Exterior
   Trunk Area Decals
   Ford VIN Decals
   Decal Packages

All General Motors Products
   Date Coded Glass
   GM Tags and Decals
   GM VIN Decals


Chrysler Products
Lights/Electrical Decals
<<  Show all Chrysler products Page 2 of 2
<< First < Prev | | Next > Last >>

HEADLIGHT/BULKHEAD WIRING HARNESS TAG HEADLIGHT/BULKHEAD WIRING HARNESS TAG
Wiring harness is routed from the bulkhead connector on the driver’s side firewall area, through the engine compartment along the top of the inner fender well and to the headlights. The tag is located approximately 3 inches down from the bulkhead connector where the tape wrap starts.

NEUTRAL SAFETY & REVERSE SWITCH HARNESS TAG NEUTRAL SAFETY & REVERSE SWITCH HARNESS TAG
Wiring harness is routed from the firewall bulkhead, down through the console tunnel along the transmission, and plugs in at the neutral safety/reverse switch that is located in the transmission housing. The tag is located approximately 6 inches from where the harness connector plugs into the switch.

MAIN TAIL LIGHT WIRING HARNESS TAG MAIN TAIL LIGHT WIRING HARNESS TAG
Wiring harness is routed inside the trunk, over the driver side wheel housing, along the rear tail light panel and ends on the passenger side of the vehicle. The tag is located approximately 1 inch from the end of the harness sheathing near the passenger side tail light.

A-12 BALLAST TO COIL WIRE CONVERSION TAG A-12 BALLAST TO COIL WIRE CONVERSION TAG
This wire routes from the ballast resistor to the coil on A-12 equipped vehicles. The tag is located in the center area of the wire extension.

Page 2 of 2
<< First < Prev | | Next > Last >>

ECS Automotive Concepts
ECS Late-Model VIN Decals
Looking for late-model (1981 thru present-day) VIN decals?
Check out www.ECSVIN.com!


MOPAR, JEEP, DODGE, HEMI, PLYMOUTH, CHRYSLER and related logos, vehicle model names and trade dress are trademarks of FCA US LLC and used under license by (licensee name). © 2015 FCA US LLC.


Copyright © 2012, ECS Automotive Concepts, LLC. All Rights Reserved.